36 Results
View results:
Sort by:
Exporting Parametric Cross-Sections from Grasshopper
I get an error when entering the name of a parametric section (for example, R_M1 500/1000) in Grasshopper.
Member Internal Forces – Units of Strain – RFEM 6
What does the unit symbol for axial and shear strain represent in RFEM 6?
Parametric Cross-Sections with Python
How can I create parametric cross-sections using Python?
Creating Nonlinear Line Hinge with Python
How can I create a nonlinear line hinge with the Python program?
Sum of Drag Forces of Zones with ParaView and Excel
Is there an option to export the results of drag forces of all zones from RWIND in a table?
Units and Decimal Places
How can I permanently save the parameters in the "Units and Decimal Places" dialog box?
Language and Region
How can I change the language and region of the graphical user interface?
Settings - Decimal Places
How can I adjust the number of decimal places in the standardized table values of a mode shape?
Question
How can I change the exponential display of the results to the display of integral numbers?
Question
The online service "Snow Load, Wind Speed, and Seismic Load Maps" displays the snow load zones 1*, 1a*, 2*, and 3* for Germany. Where are these snow load zones defined?
Displaying Results of Support Reactions
Which units are specified in the result display of the support reactions (kN or kN/m)? A note about this is missing in the graphic.
When the support reactions are given in kN/m, for which distance does the value apply?
Setting of Result Units
Where can I set the units of the results in RFEM/RSTAB?
Question
Why does the RF‑CONCRETE Surfaces add-on module not increase the amount of reinforcement until the SLS design checks have a design ratio of 1.0?
Question
I would like to import a large, curved surface from Rhino into RFEM, but I get the following error message: "Command: ExportToRFEM5. Nodes compare tolerance is set too low. You could adjust it by document units settings. Export error. Error to write data, message: Coordinate Z is out of range. Export to RFEM finished." How can I fix this error?
Question
I have entered a line support with "Wall in Z", but I cannot select the wall end for the design in RF‑PUNCH Pro. Why?
Question
In RF-/DYNAM PRO - Forced Vibrations, why does my time diagram function formula output incorrect values which appear to be off by only a factor?
Question
Which features are available for the data exchange between Grasshopper and RFEM?
Question
Is it also possible to simulate an external steel structure in RWIND Simulation?
Question
How can I correct Error No. 1663 referring to a missing rib entry in the member definition?
Question
How can I smooth continuous boundary lines of membrane cuttings?
Question
Why is the compensated cutting pattern length of a membrane surface incompatible with the defined compensation?
Why is the compensated cutting pattern length of a membrane surface incompatible with the defined compensation?